Navigating by Hyperlinks

NOTE:
The hyperlink functionality is only available in view mode Picture View. The hyperlink functionality and the screen display depends on the customized settings in the menu Catalog-Options-Operation, see Chapter Operation.

A hyperlink is indicated by a green square (item 1 in Fig. Hyperlinks) which is positioned at the position number of the corresponding part.

 

Fig.: Hyperlinks

1 Tooltip, e.g. name of the part 2 Mouse pointer 3 Marked hyperlink

4 Hyperlink 5 Highlighted hyperlink (selected part)

Select a part as follows.

1	Move the mouse pointer over the hyperlink. The hyperlink is marked inversely (item 3) and the mouse pointer changes to the symbol for a link (item 2, in general a hand symbol). The tooltip to the corresponding part (item 1, e.g. name) is displayed near the mouse pointer.

2	Click on the marked hyperlink to select the corresponding part.

3	A hyperlink that is displayed in red (item 5) indicates that the subpart is selected and that the subpart does not have a picture itself.

3.1	Normal zoom: Click on the picture with the right mouse button to center a red hyperlink, e.g. when the picture is too large to be displayed completely on the screen.

3.2	SVG zoom: Click on the picture with the right mouse button to open a popup menu, see Fig. Popup menu «SVG Zoom». Select Show selected hotspots from the menu to display the red hyperlink centered.

NOTE:
If there are hyperlinks in the picture, you will find these links in the zoomed picture as well.