Two or More Pictures

Some parts in the catalog may have more than one picture. In this case, thumbnails of the available pictures are stored additionally in the parts catalog. The display on the right side of the screen depends on the configuration of SPCat.

If a picture was assigned to be the «default» picture, it will be displayed. In this case you must select the thumbnail view (icon View Thumbnails, see Chapter Tool Bar) to display the thumbnails.

If there is no «default» picture, the thumbnails of the available pictures are displayed.

 

Fig.: Picture view (thumbnails)

1 Icon «View Thumbnails» 2 Spinner for pictures

3 Spinner for pages 4 Thumbnails

Select a picture by one of the following ways:

 

Click on the desired thumbnail (item 4 in Fig. Picture view (thumbnails)).
If the thumbnail of the desired picture is not visible cycle through the thumbnail pages using the spinner for pages (item 3 in Fig. Picture view (thumbnails), only available if there is more than one thumbnail page).
Cycle directly through the pictures by using the spinner in the tool bar (item 2 in Fig. Picture view (thumbnails)). Note that the number «zero» indicates thumbnail view.

The selected picture is displayed as described in Chapter One Picture. Click on the icon View Thumbnails (item 1 in Fig. Picture view (thumbnails)) to return to the thumbnail view.